Due to the greatly varied market demands for molds and molded products, there are many kinds of changes and thus high requirements for us in such aspects as shape, size, material, structure and more, causing us many problems and difficulties in the production process of molds and products. How to effectively control the geometric dimensions of the mold and the product is just one of them.   For different types of molds and products, there are different control techniques and methods for dimensions control. Personally, I usually start from the following aspects.   Mold Design Control Firstly, we have to fully understand the technical requirements for the mold structure, material, hardness, and precision, etc., including whether the shrinkage rate of the plastic material is proper, and whether the 3D model of the product is complete, in a bid to perform reasonable analysis.   2. Thorough consideration should be given to various factors that may influence the ...

Flash, also known as flashing or burrs, mostly occurs between the matching parts of a mold, such as the parting surface of the mold, the sliding part of the slider, the clearance of the insert, and the gap of the ejector, etc. If the flashing is not resolved in a timely manner, it will be further worsened, so that the mold will be pressed to cause local collapses or other permanent damages. The flashing occurring in the clearance of the insert and the gap of the ejector will also cause the product to stick on the mold, thus affecting ejection.   Flash is actually the excessive plastic material which enters the matching gaps of the mold and is attached to the final product after cooling. It is very easy to solve the problem of flashing, i.e., keeping the melt out of the matching gaps in a mold. The plastic melt usually enters the mold matching gaps in two scenarios: one is that the mold matching gap is large, making it easy for the melt to get in; the other is that the mold matchin...